Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

The trigger assembly that connects the button to the motor can sometimes break. This guide will explain how to replace the trigger assembly.

Parçalar

Hiçbir parça belirtilmedi.

  1. In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.
    • In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

  2. Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.
    • Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.

    • Try not to break these clips as this will cause structural integrity issues upon reassembly

  3. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Hemen Alışveriş Yapın

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Hemen Alışveriş Yapın
  4. Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate. Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.
    • Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

  5. The trigger button is held in with light tension clips. Gently pry them back to release.
    • The trigger button is held in with light tension clips. Gently pry them back to release.

  6. Remove the white trigger. Remove the white trigger.
    • Remove the white trigger.

  7. Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button
    • Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button

    • Be sure to reference the how to solder video posted to the device page

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Ian Hancock

Üyelik tarihi: 22-10-2014

405 İtibar

3 adet Kılavuz yazıldı

Takım

Baylor, Team 4-2, Williams Fall 2014 Baylor, Team 4-2, Williams Fall 2014 üyesi

BU-WILLIAMS-F14S4G2

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 14

Son 30 gün: 73

Her zaman: 4,042