Eşyalarını Tamir Et Topluluk Mağaza

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

Krups F203 Coffee Grinder Trigger Assembly Replacement

Giriş

The trigger assembly that connects the button to the motor can sometimes break. This guide will explain how to replace the trigger assembly.

Neye ihtiyacın var

  1. Krups F203 Coffee Grinder Trigger Assembly Replacement, Base Plate: adım 1, 1 resimden 1.

    • In each of the four rectangular slots on the bottom of the device, there is an E-shaped clip.

    Düzenle

  2. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 2, 3 resimden 1. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 2, 3 resimden 2. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 2, 3 resimden 3.

    • Wedge the spudger between the flat side of the E-clip and the outside wall of the slot. Then, loosen up the clip by prying it inward with the spudger.

    • Try not to break these clips as this will cause structural integrity issues upon reassembly

    Düzenle

  4. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 3, 2 resimden 1. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 3, 2 resimden 2.

    • Work your way around the four clips, loosening each a little at a time. Eventually, all four clips will be loose enough to remove the base plate.

    Düzenle

  5. Krups F203 Coffee Grinder Trigger Assembly Replacement, Detach Trigger Button from Base Plate: adım 4, 1 resimden 1.

    • The trigger button is held in with light tension clips. Gently pry them back to release.

    Düzenle

  6. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 5, 2 resimden 1. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 5, 2 resimden 2.

    • Remove the white trigger.

    Düzenle

  7. Krups F203 Coffee Grinder Trigger Assembly Replacement: adım 6, 1 resimden 1.

    • Desolder the contact points between the trigger button and the red wire and also where the plug attaches to the trigger button

    • Be sure to reference the how to solder video posted to the device page

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

Ian Hancock

Üyelik tarihi: 10/22/14

414 İtibar

3 adet Kılavuz yazıldı

Rozetler: 13

+10 tane daha rozet

Ekip

Baylor, Team 4-2, Williams Fall 2014 Baylor, Team 4-2, Williams Fall 2014 üyesi

BU-WILLIAMS-F14S4G2

3 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 30

Her zaman: 5,340