Giriş

This guide will help you replace the camera in the phone.

Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
  • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

  • Flip open the phone and locate the four screw covers.

Yorum Ekle

Remove all four screw covers by using an IPod opening tool. They should come off relatively easy.
  • Remove all four screw covers by using an IPod opening tool. They should come off relatively easy.

Yorum Ekle

Using a T6 Torx screwdriver, remove all four screws.
  • Using a T6 Torx screwdriver, remove all four screws.

Yorum Ekle

Once the screws are removed, use an IPod opening tool to separate the front cover from the inner screen cover. Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together. Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together.
  • Once the screws are removed, use an IPod opening tool to separate the front cover from the inner screen cover.

  • Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together.

Yorum Ekle

Pull the inner screen cover towards you and up in order to separate it from the front cover. Pull the inner screen cover towards you and up in order to separate it from the front cover.
  • Pull the inner screen cover towards you and up in order to separate it from the front cover.

Yorum Ekle

Remove the tape from the bottom of the LCD screen.
  • Remove the tape from the bottom of the LCD screen.

Yorum Ekle

Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen. Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen. Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen.
  • Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen.

Yorum Ekle

Flip the screen over so that you can see the outer LCD screen and the circuit board. Insert spudger in the bottom right corner. Lift up and move the spudger across the bottom.
  • Flip the screen over so that you can see the outer LCD screen and the circuit board.

  • Insert spudger in the bottom right corner.

  • Lift up and move the spudger across the bottom.

  • The third photo is rotated 180 degrees.

Yorum Ekle

Use the pointy side of the spudger to peel off the interior tape. Flip the assembly over and peel the circuit board from the screen.
  • Use the pointy side of the spudger to peel off the interior tape.

  • Flip the assembly over and peel the circuit board from the screen.

Yorum Ekle

Use the spudger to remove the LCD screen from its backing. Use the spudger to remove the LCD screen from its backing.
  • Use the spudger to remove the LCD screen from its backing.

Yorum Ekle

Carefully slide the spudger behind the main ribbon in order to separate it from the inside cover of the phone.
  • Carefully slide the spudger behind the main ribbon in order to separate it from the inside cover of the phone.

Yorum Ekle

Use a spudger to pop off the camera ribbon from the main ribbon. The camera component should separate entirely. Use a spudger to pop off the camera ribbon from the main ribbon. The camera component should separate entirely.
  • Use a spudger to pop off the camera ribbon from the main ribbon. The camera component should separate entirely.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

Üyelik tarihi: 16-04-2010

8 İtibar

16 adet Kılavuz yazıldı

Takım

Cal Poly, Team 6-14, Maness Spring 2010 Cal Poly, Team 6-14, Maness Spring 2010 üyesi

CPSU-MANESS-S10S6G14

4 Üyeler

16 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 1,159