Ana içeriğe geç

Giriş

A guide to replace the antenna.

Parçalar

Hiçbir parça belirtilmedi.

  1. Turn the phone on its back. Turn the phone on its back.
    • Turn the phone on its back.

  2. Orient the phone as shown. Remove the battery cover by pushing upward with your thumb.
    • Orient the phone as shown.

    • Remove the battery cover by pushing upward with your thumb.

  3. Place your fingernail at the top of the battery and pry the battery out towards you. Place your fingernail at the top of the battery and pry the battery out towards you.
    • Place your fingernail at the top of the battery and pry the battery out towards you.

  4. Orient the phone as shown with the battery already removed.
    • Orient the phone as shown with the battery already removed.

  5. Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın
  6. Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards. Use a Phillips #00 screwdriver to remove the 5 screws as shown here. Use a Phillips #00 screwdriver to remove the 5 screws as shown here.
    • Remove the 2 plastic plugs located on the side and upper quadrant of the rear body panel by using the push-pin and lifting outwards.

    • Use a Phillips #00 screwdriver to remove the 5 screws as shown here.

  7. Place an iPod opener tool in the seam above the antenna. Run the tool around the perimeter of the entire phone. Run the tool around the perimeter of the entire phone.
    • Place an iPod opener tool in the seam above the antenna.

    • Run the tool around the perimeter of the entire phone.

  8. Check to see that your device looks like the attached photo.
    • Check to see that your device looks like the attached photo.

  9. Locate the screw and copper fixture that hold the antenna in place.
    • Locate the screw and copper fixture that hold the antenna in place.

    • Remove the screw from the device using a Philips #00 screwdriver.

  10. Remove the copper fixture after it has been unscrewed. Remove the copper fixture after it has been unscrewed.
    • Remove the copper fixture after it has been unscrewed.

  11. Check to see that your device looks like the attached photo. Check to see that your device looks like the attached photo.
    • Check to see that your device looks like the attached photo.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Douglas Blaalid

Üyelik tarihi: 13-01-2010

282 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-13, Forte Winter 2010 Cal Poly, Team 4-13, Forte Winter 2010 üyesi

CPSU-FORTE-W10S4G13

5 Üyeler

15 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 2,315