Giriş

Use this guide to replace the Flash Diffuser.

Parçalar

Hiçbir parçaya gerek yok.

Carefully unscrew the four (4) screws on the bottom of the camera.
  • Carefully unscrew the four (4) screws on the bottom of the camera.

  • Make sure you don't miss the one that's actually in the tripod socket hole.

Yorum Ekle

Open the back door on the camera by pushing down on the door latch.
  • Open the back door on the camera by pushing down on the door latch.

Yorum Ekle

  • Apply pressure to the bottom plate and it will pop off.

  • From here, you can replace the bottom plate, or continue on to further steps.

Yorum Ekle

  • Now that you've removed the bottom plate, you can pull apart the front and back covers.

  • Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.

Yorum Ekle

  • Next, the back cover.

  • Apply pressure to remove the back plate.

  • Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.

  • The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.

Yorum Ekle

  • You should now have removed the front and back plates.

Yorum Ekle

  • Removing the flash diffuser should be simple from here.

  • Simply take the front cover and apply pressure to the front of the flash diffuser and it should pop right out.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Kenny

Üyelik tarihi: 10-04-2011

51 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-19, Garner Spring 2011 Cal Poly, Team 18-19, Garner Spring 2011 üyesi

CPSU-GARNER-S11S18G19

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 3

Her zaman: 2,377