Aletler

Parçalar

Hiçbir parçaya gerek yok.

Carefully unscrew the four (4) screws on the bottom of the camera.
  • Carefully unscrew the four (4) screws on the bottom of the camera.

  • Make sure you don't miss the one that's actually in the tripod socket hole.

Yorum Ekle

Open the back door on the camera by pushing down on the door latch.
  • Open the back door on the camera by pushing down on the door latch.

Yorum Ekle

  • Apply pressure to the bottom plate and it will pop off.

  • From here, you can replace the bottom plate, or continue on to further steps.

Yorum Ekle

  • Having opened the camera and removed the bottom plate, unscrew the five screws marked in the picture.

  • The screw marked in blue is a tiny bit harder to find because it's in a crevice. Don't miss it!

Yorum Ekle

  • Apply pressure until the piece you unscrewed in the last step pops off.

Yorum Ekle

  • Unscrew the four screws on the back of this piece to the lower-left corner of the lens.

Yorum Ekle

  • Removing the lens motor cover, you should be left with these four pieces.

Yorum Ekle

  • Located underneath these four pieces is the lens motor.

Yorum Ekle

  • Now that you've removed the bottom plate, you can pull apart the front and back covers.

  • Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.

Yorum Ekle

  • Next, the back cover.

  • Apply pressure to remove the back plate.

  • Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.

  • The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.

Yorum Ekle

  • You should now have removed the front and back plates.

Yorum Ekle

  • Remove the four screws holding on the front panel surrounding the lens.

Yorum Ekle

  • Remove the three gears under the panel you removed in the last step and the lens motor should be able to be removed.

Yorum Ekle

  • Now that the lens motor has been removed, you can apply pressure to the back of the lens and push it out.

  • From here, locate the three screws near the front of the lens.

  • Unscrew these three screws.

Yorum Ekle

  • From here, you can pull out the small disk containing the lens cover.

  • Unscrew the four screws on the back and pull the two pieces of the disk apart.

Yorum Ekle

  • From here, you can replace any broken parts in the lens cover.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Kenny

Üyelik tarihi: 10-04-2011

51 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-19, Garner Spring 2011 Cal Poly, Team 18-19, Garner Spring 2011 üyesi

CPSU-GARNER-S11S18G19

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 2,118