Eşyalarını Tamir Et Topluluk Mağaza

Leica Z2X Lens Motor Replacement

Neye ihtiyacın var

  1. Leica Z2X Lens Motor Replacement, Remove the Bottom Screws: adım 1, 1 resimden 1.

    • Carefully unscrew the four Phillips #0 screws on the bottom of the camera.

    • There is a screw located inside of the tripod hole (large circle.) Make sure the screw is removed from there too!

    Düzenle

  2. Leica Z2X Lens Motor Replacement, Open the Back Door: adım 2, 1 resimden 1.

    • Open the back door on the camera by pushing down on the door latch.

    Düzenle

  3. Leica Z2X Lens Motor Replacement, Remove the Bottom Plate: adım 3, 1 resimden 1.

    • Apply pressure to the bottom plate and it will pop off.

    • From here, you can replace the bottom plate, or continue on to further steps.

    Düzenle

  4. Leica Z2X Lens Motor Replacement, Lens Motor: adım 4, 1 resimden 1.

    • Having opened the camera and removed the bottom plate, unscrew the five screws marked in the picture.

    • The screw marked in blue is a tiny bit harder to find because it's in a crevice. Don't miss it!

    Düzenle

  5. Leica Z2X Lens Motor Replacement: adım 5, 1 resimden 1.

    • Apply pressure until the piece you unscrewed in the last step pops off.

    Düzenle

  7. Leica Z2X Lens Motor Replacement: adım 6, 1 resimden 1.

    • Unscrew the four screws on the back of this piece to the lower-left corner of the lens.

    Düzenle

  8. Leica Z2X Lens Motor Replacement: adım 7, 1 resimden 1.

    • Removing the lens motor cover, you should be left with these four pieces.

    Düzenle

  9. Leica Z2X Lens Motor Replacement: adım 8, 1 resimden 1.

    • Located underneath these four pieces is the lens motor.

    Düzenle

  10. Leica Z2X Lens Motor Replacement: adım 9, 1 resimden 1.

    • Now that you've removed the bottom plate, you can pull apart the front and back covers.

    • Start with the front cover and, by applying pressure (perhaps a lot of pressure), snap off the front cover.

    Düzenle

  11. Leica Z2X Lens Motor Replacement: adım 10, 1 resimden 1.

    • Next, the back cover.

    • Apply pressure to remove the back plate.

    • Be careful of the buttons on the top of the camera falling off, they are small parts and CAN get lost easily.

    • The best way to remove the back is to stick your thumbs on either side of the battery socket and separate from there.

    Düzenle

  12. Leica Z2X Lens Motor Replacement: adım 11, 1 resimden 1.

    • You should now have removed the front and back plates.

    Düzenle

  13. Leica Z2X Lens Motor Replacement: adım 12, 1 resimden 1.

    • Remove the four screws holding on the front panel surrounding the lens.

    Düzenle

  14. Leica Z2X Lens Motor Replacement: adım 13, 1 resimden 1.

    • Remove the three gears under the panel you removed in the last step and the lens motor should be able to be removed.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

Zachary

Üyelik tarihi: 04/12/11

46 İtibar

2 adet Kılavuz yazıldı

Rozetler: 8

+5 tane daha rozet

Ekip

Cal Poly, Team 18-19, Garner Spring 2011 Cal Poly, Team 18-19, Garner Spring 2011 üyesi

CPSU-GARNER-S11S18G19

4 Üyeler

13 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 10

Her zaman: 2,611