Giriş

The following guide details the neccesary steps that you have to follow in order to replace the vibration motor of the Lenovo IdeaTab S6000.

Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.
  • Remove speaker screens by working them lose with a plastic opening tool. You may need to first losen them with iFixit tweasers or a craft knife.

  • These screens are held in place by glue and are hard to remove. Take your time.

Yorum Ekle

Remove the 3.14" Philips screws from both spots that were covered.
  • Remove the 3.14" Philips screws from both spots that were covered.

Yorum Ekle

Go all around the casing prying the screen away from the backing with a spudger.
  • Go all around the casing prying the screen away from the backing with a spudger.

  • It will make a popping sound each time one of the lock tabs is disconnected.

  • DO NOT USE A METAL TOOL FOR THIS.

  • Take your time as you move all around the device prying the backing off.

Yorum Ekle

Pull off the plastic covering the battery cable.
  • Pull off the plastic covering the battery cable.

Yorum Ekle

Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers. Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.
  • Gently pull on both sides of the plug to release it with either a plastic opening tool or your fingers.

Yorum Ekle

Remove the battery by grabbing the tab shown and pulling up.
  • Remove the battery by grabbing the tab shown and pulling up.

  • The battery is held to the device by a bit of adhesive. Just pull the battery up from the tab and it will lift out with a bit effort.

Yorum Ekle

Use a spudger to pry the vibration motor up.
  • Use a spudger to pry the vibration motor up.

Yorum Ekle

This step is not necessary if you aren't replacing the vibration motor. To remove wires first heat up soldering gun.
  • This step is not necessary if you aren't replacing the vibration motor.

  • To remove wires first heat up soldering gun.

  • Heat up metal connecting the wires to the board.

  • Once the metal is heated to a melting point gently pull on the wire. The wires should come out with little effort.

  • The red wire goes on the left and the blue on the right.

  • To connect new vibration switch simply follow these steps in reverse.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Gabriel Delgado

Üyelik tarihi: 22-09-2014

228 İtibar

1 Kılavuz yazıldı

Takım

USF Tampa, Team 10-4, Brown Fall 2014 USF Tampa, Team 10-4, Brown Fall 2014 üyesi

USFT-BROWN-F14S10G4

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 4

Son 30 Gün: 10

Tüm Zamanlar: 739