Ana içeriğe geç

Giriş

The hard drive is a storage device that permanently stores information. If you have a faulty hard drive or you are upgrading it, this guide will help you replace it.

Parçalar

Hiçbir parça belirtilmedi.

  1. Ensure the device is off and unplugged.
    • Ensure the device is off and unplugged.

    • Remove the stylus from its port and set aside.

  2. Using a Phillips screwdriver, unscrew the 8 PH1 Phillips fasteners until you hear an audible click. The screws will not separate from the bottom cover when loose.
    • Using a Phillips screwdriver, unscrew the 8 PH1 Phillips fasteners until you hear an audible click.

    • The screws will not separate from the bottom cover when loose.

  3. The bottom cover is attached via several plastic clips located around the edges of the bottom cover. Using a plastic opening tool, gently pry the bottom cover from the laptop.
    • The bottom cover is attached via several plastic clips located around the edges of the bottom cover.

    • Using a plastic opening tool, gently pry the bottom cover from the laptop.

    • Work the plastic opening tool around the edges of the bottom cover undoing all of the plastic clips, as shown in the picture.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Place your fingers around the edges of the cover and remove it. Place your fingers around the edges of the cover and remove it.
    • Place your fingers around the edges of the cover and remove it.

  6. Pull back the plastic heat shield over the hard drive without tearing or completely removing it. Pull back the plastic heat shield over the hard drive without tearing or completely removing it. Pull back the plastic heat shield over the hard drive without tearing or completely removing it.
    • Pull back the plastic heat shield over the hard drive without tearing or completely removing it.

  7. Using a Phillips screwdriver, remove the PH1 Phillips fastener and set it aside.
    • Using a Phillips screwdriver, remove the PH1 Phillips fastener and set it aside.

  8. Using your index finger and thumb, gently pull the hard drive from its connection and remove it from the laptop.
    • Using your index finger and thumb, gently pull the hard drive from its connection and remove it from the laptop.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Daniel Fernandez

Üyelik tarihi: 14-02-2018

759 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team S2-G3, Eyestone Spring 2018 USF Tampa, Team S2-G3, Eyestone Spring 2018 üyesi

USFT-EYESTONE-S18S2G3

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 30

Son 30 Gün: 128

Her zaman: 1,136