Linksys WAP 11 Outer Case Replacement

Disconnect the power cables and ethernet from the device.

Unscrew the external plastic antennas. There is one antenna on each side of the device.

Use the tweezers to remove the two rubber boots from the front two legs. Insert the tweezers in the hole of the boot and pull outwards.

This will reveal two small Phillips-head screws. Remove them.

Using two hands, pull on the top and bottom sections to separate the blue and the black pieces.

The seal is located where the blue plastic meets the black plastic. This is where you will apply pressure.

After the face of the device has been removed, slide the base of the device off to reveal the motherboard and other internal components.

This is what the device looks like when it is fully opened.