Ana içeriğe geç

Logitech Extreme 3D Pro Disassembly of the base

Neye ihtiyacın var

  1. Logitech Extreme 3D Pro Disassembly of the base, Disassembly of the handle: adım 1, 1 resimden 1.
    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

  2. Logitech Extreme 3D Pro Disassembly of the base: adım 2, 1 resimden 1.
    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

  3. Logitech Extreme 3D Pro Disassembly of the base: adım 3, 2 resimden 1. Logitech Extreme 3D Pro Disassembly of the base: adım 3, 2 resimden 2.
    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

  4. Logitech Extreme 3D Pro Disassembly of the base, Disassembly of the base: adım 4, 1 resimden 1.
    • Remove the eight 10mm Phillips #1 screws from the bottom.

  5. Logitech Extreme 3D Pro Disassembly of the base: adım 5, 3 resimden 1. Logitech Extreme 3D Pro Disassembly of the base: adım 5, 3 resimden 2. Logitech Extreme 3D Pro Disassembly of the base: adım 5, 3 resimden 3.
    • Flip the joystick upright.

    • Lift up the sliver base cover and feed the loose circuit board through.

    • Careful with the wires still attached to the silver base cover from the bottom of the joystick.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Emanuel Canela

Üyelik tarihi: 01/25/18

1.297 İtibar

7 adet Kılavuz yazıldı

Ekip

USF Tampa, Team S7-G1, Passmore Spring 2018 USF Tampa, Team S7-G1, Passmore Spring 2018 üyesi

USFT-PASSMORE-S18S7G1

4 Üyeler

7 adet Kılavuz yazıldı

Bir Yorum

And you didn’t even finish the repair. Thanks for nothing. :(

Jesse James - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 5

Son 7 gün: 12

Son 30 gün: 56

Her zaman: 3,609