Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

After a long use the joystick trigger might experience a lack of strength within the trigger's internal spring.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove these three Phillips #1 screws:
    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

  2. Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

  3. Essential Electronics Toolkit

    Small Toolkit. Big Possibilities.

    Shop Toolkits

    Essential
    Electronics
    Toolkit

    Shop Toolkits
  4. Pull apart the joystick chassis by hand. Release this clip located underneath the  hand rest
    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

  5. Remove the plastic trigger from the joystick.
    • Remove the plastic trigger from the joystick.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Emanuel Canela

Üyelik tarihi: 25-01-2018

878 İtibar

7 adet Kılavuz yazıldı

Takım

USF Tampa, Team S7-G1, Passmore Spring 2018 USF Tampa, Team S7-G1, Passmore Spring 2018 üyesi

USFT-PASSMORE-S18S7G1

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 3

Son 30 gün: 24

Her zaman: 389