Ana içeriğe geç

Giriş

prereq for removing IO board side display screws and heatsink screw

  1. Remove the two 5.6 mm T8 Torx screws securing the antenna cable retainer on the left display hinge to the upper case.
    • Remove the two 5.6 mm T8 Torx screws securing the antenna cable retainer on the left display hinge to the upper case.

  2. Push the antenna cable retainer out of the way and remove the single 3 mm T5 Torx screw securing the end of the heat sink to the upper case.
    • Push the antenna cable retainer out of the way and remove the single 3 mm T5 Torx screw securing the end of the heat sink to the upper case.

Sonuç

To reassemble your device, follow these instructions in reverse order.

iRobot

Üyelik tarihi: 24-09-2009

1 İtibar

647 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 21