Eşyalarını Tamir Et Topluluk Mağaza

MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement

Giriş

Use this guide to replace a dead AirPort/Bluetooth card to regain Wi-Fi capability.

Neye ihtiyacın var

  1. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement, Lower Case: adım 1, 1 resimden 1.
    Bu adımda kullanılan alet:
    P5 Pentalobe Screwdriver Retina MacBook Pro and Air
    $5.99
    Satın Al

    • Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.

    • Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:

    • Two 9 mm screws

    • Eight 2.6 mm screws

    Düzenle

  2. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement: adım 2, 1 resimden 1.

    • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

    • Remove the lower case and set it aside.

    Düzenle

  4. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement, Battery Connector: adım 3, 2 resimden 1. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement, Battery Connector: adım 3, 2 resimden 2.

    • As a precaution against accidental discharge or shock, disconnect the battery connector from the logic board.

    • Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.

    • Be sure to pull the connector horizontally toward the battery, and not straight up from the Air, or you may damage the socket on the logic board.

    Düzenle

  5. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: adım 4, 2 resimden 1. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: adım 4, 2 resimden 2.

    • Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.

    Düzenle

  6. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement: adım 5, 1 resimden 1.

    • Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.

    Düzenle

  7. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement: adım 6, 2 resimden 1. MacBook Air 13" Mid 2011 AirPort/Bluetooth Card Replacement: adım 6, 2 resimden 2.

    • Slightly lift the free end of the AirPort/Bluetooth card and pull it out of its socket on the logic board.

    • To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.

    • Remove the AirPort/Bluetooth card from the Air.

    Düzenle
Bitiş Çizgisi

25 farklı kişi bu kılavuzu tamamladı.

9 Yorum

Is there any way to exchange the installed AirPort/Bluetooth Card with a newer one providing W-LAN AC?

Skyynet - Yanıt

Is tihs card is the same as in to Macbook Air 11 ?

Petar Slavchev - Yanıt

is it possible to renew on of the two antenna cables, because mine get broken while lifting it

milankoehnke1995 - Yanıt

Did you ever find the cables for sale anywhere? Thanks.

edwalker263 -

Can I replace this card with a newer one that allows Apple Watch unlock in Sierra?

Aaron - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 gün: 24

Son 30 gün: 83

Her zaman: 46,280