Ana içeriğe geç

Giriş

This serves as the starting point for every guide—you'll need a P5 Pentalobe screwdriver to remove the lower case and get into the device.

    • Remove the following ten screws securing the lower case to the upper case:

    • Two 2.3 mm Pentalobe screws

    • Eight 3.0 mm Pentalobe screws

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

  1. Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın

    Apple Watch Kitleri

    Screen and battery repairs just got easier.

    Hemen Alışveriş Yapın
  2. Wedge your fingers between the upper case and the lower case.
    • Wedge your fingers between the upper case and the lower case.

    • Gently pull the lower case away from the upper case to remove it.

  3. The lower case is connected to the upper case with two plastic clips near its center. During reassembly, gently push down the center of the lower case to reattach the two plastic clips.
    • The lower case is connected to the upper case with two plastic clips near its center.

    • During reassembly, gently push down the center of the lower case to reattach the two plastic clips.

Sonuç

To reassemble your device, follow these instructions in reverse order.

11 farklı kişi bu kılavuzu tamamladı.

Andrew Optimus Goldheart

Üyelik tarihi: 17-10-2009

423.252 İtibar

411 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

101 Üyeler

9.063 adet Kılavuz yazıldı

Bir Yorum

Nice………………..!

Fred Starbuck - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 20

Son 7 Gün: 125

Son 30 Gün: 626

Her zaman: 22,783