MacBook Pro 15" Retina Display Mid 2012 AirPort/Camera Cable Replacement

Adım 1 AirPort/Camera Cable

• Use a spudger or tweezers to pry the three AirPort antenna cables straight up off of their sockets on the AirPort board.
• The cable connection points are fragile. Be careful to lift only on the connector, and not on the socket or cable.
• To reconnect, align the connector carefully into position over the socket, and press it down firmly with the flat of your spudger.
Düzenle
55 yorum
Yorum Ekle
Yorum Ekle
1024
İptal Yorum gönder
Adım 2

• Use the tip of a spudger to push the camera cable connector toward the fan and out of its socket on the logic board.
• Be sure to push parallel to the board, first on one side, then the other, to slowly "walk" the connector out of its socket. Do not pry up, or you will damage the socket.
Düzenle
34 yorum
Yorum Ekle
Yorum Ekle
1024
İptal Yorum gönder
Adım 3
• Insert the flat end of a spudger underneath the rubber heat sink cover on the right fan.
• Slide the spudger underneath the length of the cover, releasing the adhesive.
• Lift the cover and flip it back so that you can access the cables underneath.
Düzenle
4 yorum
Yorum Ekle
Yorum Ekle
1024
İptal Yorum gönder
Adım 4
• Use your fingers to pull the AirPort/Camera cables up off the fan.
• The cables are adhered to the fan, so peel them up carefully to avoid damaging them.
• Carefully de-route the cables from the plastic cable guide.
Düzenle
2 yorum
Yorum Ekle
Yorum Ekle
1024
İptal Yorum gönder

Yazar

8 tane daha katılımcı ile

Brett Hartt

Üyelik tarihi: 04/12/10

127.876 İtibar

143 adet Kılavuz yazıldı

Rozetler: 52

• 
• 
• 

+49 tane daha rozet

Ekip

iFixit iFixit üyesi

Staff

135 Üyeler

16.732 adet Kılavuz yazıldı

Bu kılavuzu göm

Bu kılavuzu, sitenizin / forumunuzun içine küçük bir parçacık olarak yerleştirmek için, bir boyut seçin ve aşağıdaki kodu kopyalayın.

Önizleme