Eşyalarını Tamir Et Topluluk Mağaza

MacBook Unibody Model A1342 Rear Speaker Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Giriş

This guide is an internal private guide used as a prereq.

Neye ihtiyacın var

  1. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement, Rear Speaker Assembly: adım 1, 1 resimden 1.

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

    Düzenle

  2. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 2, 1 resimden 1.

    • Remove the following screws securing the right speaker assembly to the upper case:

    • One 12 mm Phillips screw.

    • One 3 mm Phillips screw.

    Düzenle

  3. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 3, 1 resimden 1.

    • Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

    Düzenle

  5. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 4, 2 resimden 1. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 4, 2 resimden 2.

    • Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card.

    • De-route the long antenna from its channel in the rear speaker housing.

    Düzenle

  6. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 5, 1 resimden 1.

    • Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.

    Düzenle

  7. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 6, 1 resimden 1.

    • Remove the rear speaker assembly from the upper case.

    Düzenle

  8. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 7, 2 resimden 1. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 7, 2 resimden 2.

    • Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly.

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.

    Düzenle

  9. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 8, 1 resimden 1.

    • Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.

    Düzenle

  10. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: adım 9, 1 resimden 1.

    • Lift the AirPort/Bluetooth board up off the rear speaker assembly.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 695