Ana içeriğe geç

Giriş

This repair may be necessary, as the eyes in the T-Rex can easily break or stop lighting up. In order to begin this repair, all you need is a small JIS #1 screwdriver, wire cutter, LED bulb, and a small pair of tweezers.

  1. Open the jaw of the T-Rex to reveal the screw on the roof of its mouth.
    • Open the jaw of the T-Rex to reveal the screw on the roof of its mouth.

  2. Using a JIS #1 screwdriver, remove the 9.6mm screw.
    • Using a JIS #1 screwdriver, remove the 9.6mm screw.

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Using tweezers or wire cutters for tension, remove the cover to reveal the LED assembly.
    • Using tweezers or wire cutters for tension, remove the cover to reveal the LED assembly.

  5. Remove the plastic cover from the top of the LED.
    • Remove the plastic cover from the top of the LED.

  6. Hold the LED to remove slack from the wires, and cut the wires as shown to remove the faulty LED.
    • Hold the LED to remove slack from the wires, and cut the wires as shown to remove the faulty LED.

Sonuç

To reassemble your device, follow these instructions in reverse order. Use a soldering station to solder new LED onto the fresh-cut wires.

Vincent Crabtree

Üyelik tarihi: 27-03-2018

267 İtibar

2 adet Kılavuz yazıldı

Takım

IUPUI, Team S3-G3, Harley Spring 2018 IUPUI, Team S3-G3, Harley Spring 2018 üyesi

IUPUI-HARLEY-S18S3G3

3 Üyeler

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 56