Eşyalarını Tamir Et Topluluk Mağaza

Mavic 2 Main Board Replacement

Giriş

  1. Turn drone upside down to expose underside plate.
  2. Begin to remove all 8 screws from the plate . Remember the 2 middle screws are bigger than the other 6 so set those aside separately.
  3. Pull plate off, exposing the main board.
  4. Detach 3 ribbons on the top of the board. Near the head of the drone. Use spreader.
  5. Remove screw holding circuit board in. 1 near the top, 2 near the bottom.
  6. Pop of all 4 antennas at the bottom of the circuit board. Use spreader.
  7. Pull away antennas and remove board carefully.
  8. Replace new circuit board.
  9. Attach 3 ribbons.
  10. Attach 4 antennas.
  11. Screw circuit board back in.
  12. Place the plate back on and screw back in all 8 screws.

Neye ihtiyacın var

  1. Mavic 2 Main Board Replacement, Remove screws: adım 1, 1 resimden 1.

    • Begin to remove screws from belly of drone.

    Düzenle

  2. Mavic 2 Main Board Replacement, Continue to remove screws: adım 2, 3 resimden 1. Mavic 2 Main Board Replacement, Continue to remove screws: adım 2, 3 resimden 2. Mavic 2 Main Board Replacement, Continue to remove screws: adım 2, 3 resimden 3.

    • remove the rest of the screws

    Düzenle

  4. Mavic 2 Main Board Replacement: adım 3, 2 resimden 1. Mavic 2 Main Board Replacement: adım 3, 2 resimden 2.

    • After all 8 Screws are removed. Remove the back panel. Keep in mind there is a ribbon connecting the panel and the main board. You must detach the ribbon from either side.

    Düzenle

  5. Mavic 2 Main Board Replacement: adım 4, 1 resimden 1.

    • Unscrew the screws holding the board in place, as well as all the ribbons and antennas connecting the board to the frame.

    Düzenle

  6. Mavic 2 Main Board Replacement: adım 5, 1 resimden 1.

    • Then remove the old board. Replace the new board you have and repeat the process in reverse.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Bir Yorum

Hello sir,

I have a question and I hope to find the answer

The plane (Mavic 2) collided with a pilot turned into a pole, and after that, I find a stutter in the camera from time to time, so I hope to find a way to solve this problem since the camera works, the camera shake.

Amr Ahmed - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 9

Son 30 gün: 29

Her zaman: 1,464