Giriş

We will be disassembling the laptop down to the heatsink and CPU, to apply some thermal paste with a higher grade of conductivity.

Remove the battery by sliding both sliders to the left.
  • Remove the battery by sliding both sliders to the left.

  • Hold the left slider as you slide the battery away from you.

Yorum Ekle

Press and hold the power button for 10 - 15 seconds, to release any excess power from the laptop.
  • Press and hold the power button for 10 - 15 seconds, to release any excess power from the laptop.

Yorum Ekle

After removing the battery, undo the single screw holding the RAM compartment lid.
  • After removing the battery, undo the single screw holding the RAM compartment lid.

  • Gently pop out the lid with a few clicks.

Yorum Ekle

Undo the white and black cable, and the screw.
  • Undo the white and black cable, and the screw.

    • Lift the wifi board up and away from you.

Yorum Ekle

Pry the metal clips holding the RAM units outward which will make the uint pop upwards. Slide the unit out, towards you.
  • Pry the metal clips holding the RAM units outward which will make the uint pop upwards.

  • Slide the unit out, towards you.

Yorum Ekle

Undo the single screw holding the hard drive lid.
  • Undo the single screw holding the hard drive lid.

Yorum Ekle

Undo the single screw holding the hard drive.
  • Undo the single screw holding the hard drive.

Yorum Ekle

Use the black tab to slide the hard drive backwards. Pry the hard drive up, on the far side and it slides out.
  • Use the black tab to slide the hard drive backwards.

  • Pry the hard drive up, on the far side and it slides out.

  • Be careful when prying the hard drive out of the case, you might drop it and damage it.

Yorum Ekle

Push the 4 black tabs located at the top of the keyboard, under the case. Push the 4 black tabs located at the top of the keyboard, under the case.
  • Push the 4 black tabs located at the top of the keyboard, under the case.

Yorum Ekle

Be careful when removing the keyboard from the case, it is still attached at the bottom. Pry the black tab backwards, to remove the cable.
  • Be careful when removing the keyboard from the case, it is still attached at the bottom.

  • Pry the black tab backwards, to remove the cable.

Yorum Ekle

On the bottom of the case there are 2 sliders, use these to release the optical drive. On the bottom of the case there are 2 sliders, use these to release the optical drive.
  • On the bottom of the case there are 2 sliders, use these to release the optical drive.

Yorum Ekle

Undo the 11 screws holding the bottom of the case.
  • Undo the 11 screws holding the bottom of the case.

Yorum Ekle

Remove the 2 cables, revealed by removing the keyboard. The cables mentioning "MB" can only be removed after opening the case. Remove the 2 cables, revealed by removing the keyboard. The cables mentioning "MB" can only be removed after opening the case.
  • Remove the 2 cables, revealed by removing the keyboard. The cables mentioning "MB" can only be removed after opening the case.

Yorum Ekle

Pry open the case using something soft, preferably your hands or a spudger.
  • Pry open the case using something soft, preferably your hands or a spudger.

Yorum Ekle

When the case is completely lose it will still be attached by the "MB" cables. Remove those before completely removing the case.
  • When the case is completely lose it will still be attached by the "MB" cables. Remove those before completely removing the case.

Yorum Ekle

Undo the single screw holding the motherboard.
  • Undo the single screw holding the motherboard.

  • Undo the 4 cables highlighted in blue.

Yorum Ekle

Also remove the black and white wifi cable from under the motherboard.
  • Also remove the black and white wifi cable from under the motherboard.

Yorum Ekle

Lift the motherboard out of its socket. The bottom left may get stuck a bit. Don't force the USB sockets.
  • Lift the motherboard out of its socket. The bottom left may get stuck a bit. Don't force the USB sockets.

Yorum Ekle

On the flipside of the motherboard is the CPU covered by the heatsink. Before removing the heatsink, remove the fan cable looping over the heatsink.
  • On the flipside of the motherboard is the CPU covered by the heatsink.

  • Before removing the heatsink, remove the fan cable looping over the heatsink.

  • Remove the 6 screws, holding the heatsink.

Yorum Ekle

First you will need a card to scrape off the old paste. Keep a coffee filter ready to clean the card.
  • First you will need a card to scrape off the old paste. Keep a coffee filter ready to clean the card.

  • Both the heatsink and CPU's must be totally cleaned of any remaining grease.

  • The triangular part on the heatsink leads to the graphics card.

Yorum Ekle

Be very thorough, any remaining grease may render your new layer of paste useless.
  • Be very thorough, any remaining grease may render your new layer of paste useless.

  • The top cores are the CPU, still not cleaned.

  • The bottom core is the newly cleaned video card CPU.

Yorum Ekle

Use alcohol or a oil-free degreaser and coffee filters or a lint-free cloth. Use alcohol or a oil-free degreaser and coffee filters or a lint-free cloth.
  • Use alcohol or a oil-free degreaser and coffee filters or a lint-free cloth.

Yorum Ekle

  • Apply the paste on the CPU's very carefully, you don't want certain thermal pastes on electrical circuits.

  • Your paste needs to be distributed evenly on the whole metal cap of the CPU.

  • Reverse engineer this guide to put the laptop back together.

  • Let the paste settle in by letting the computer run for a few consecutive hours.

  • Run a temperature monitor software to check if your application has been effective or not. After a day or two, you may want to stress-test it by running some high end application all together and monitor the temperature.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

6 başka kişi bu kılavuzu tamamladı.

Ikfixda

Üyelik tarihi: 03-07-2011

365 İtibar

1 Kılavuz yazıldı

Bir Yorum

Diese Anleitung zum Öffnen und Ausbauen des Kühlers ist ebenfalls anwendbar für das Medion Akoya P6624 (MD98390)

Lutz - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 Gün: 26

Son 30 Gün: 94

Her zaman: 9,692