Giriş

This guide will help locate the microphone for removal and/or repair.

Parçalar

Hiçbir parçaya gerek yok.

Flip over the phone and then slide down the back cover with your thumb.
  • Flip over the phone and then slide down the back cover with your thumb.

Yorum Ekle

Lever out the battery from the phone using your thumb.
  • Lever out the battery from the phone using your thumb.

Yorum Ekle

Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
  • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

Yorum Ekle

Gently pull off hinge cap piece from the the top of the phone.
  • Gently pull off hinge cap piece from the the top of the phone.

Yorum Ekle

Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
  • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

Yorum Ekle

Open the phone and turn it on its side. Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
  • Open the phone and turn it on its side.

  • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

Yorum Ekle

Using your hand, gently pull of the back panel from the bottom half of the phone.
  • Using your hand, gently pull of the back panel from the bottom half of the phone.

Yorum Ekle

Close the phone and place it on a flat surface.
  • Close the phone and place it on a flat surface.

  • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

  • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

Yorum Ekle

On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
  • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

  • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

Yorum Ekle

Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool
  • Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool

Yorum Ekle

On the back of the separated battery compartment, locate the small speaker module in the lower left hand corner
  • On the back of the separated battery compartment, locate the small speaker module in the lower left hand corner

Yorum Ekle

Using a plastic opening tool, pry out the microphone from the bottom
  • Using a plastic opening tool, pry out the microphone from the bottom

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Andrew

Üyelik tarihi: 04-10-2010

358 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-46, Amido Fall 2010 Cal Poly, Team 4-46, Amido Fall 2010 üyesi

CPSU-AMIDO-F10S4G46

4 Üyeler

14 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 4

Tüm Zamanlar: 120