Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

In the event that the buttons on the side of the Microsoft Band 2 become jammed or unresponsive, follow this guide to learn how to remove them for cleaning or replacement.

  1. Wear proper gloves when using a heatgun.
    • Wear proper gloves when using a heatgun.

    • Use a heatgun to melt the adhesive beneath the screen. Heat the metal around edges of the screen.

    • Avoid heating the rubber watch band as it will quickly melt.

    • Heating the LCD screen may damage it. Avoid this procedure unless you intend to replace the screen.

  2. Use metal tweezers to gently detach the orange press-fit (or "pop") connector. Use metal tweezers to gently detach the orange press-fit (or "pop") connector.
    • Use metal tweezers to gently detach the orange press-fit (or "pop") connector.

  3. Use the T3 Torx Screwdriver to remove the two 2.7 mm screws
    • Use the T3 Torx Screwdriver to remove the two 2.7 mm screws

  4. Lift the logic board and locate the two circular clips securing the buttons from inside the wall of the Band 2. Remove them by sliding the clips sideways.
    • Lift the logic board and locate the two circular clips securing the buttons from inside the wall of the Band 2. Remove them by sliding the clips sideways.

  5. Remove the buttons, being careful not to lose the springs.
    • Remove the buttons, being careful not to lose the springs.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Chris Syracuse

Üyelik tarihi: 20-02-2017

637 İtibar

3 adet Kılavuz yazıldı

Takım

USF Tampa, Team S1-G5, Leahy Spring 2017 USF Tampa, Team S1-G5, Leahy Spring 2017 üyesi

USFT-LEAHY-S17S1G5

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 2

Son 30 gün: 10

Her zaman: 1,140