Giriş

Looks as though some experience with a soldering tool may be necessary, so make sure to be safe with these steps!

First, apply pressure with your thumb on the top of the battery cover.
  • First, apply pressure with your thumb on the top of the battery cover.

Yorum Ekle

Next, pull down on the cover until it begins to slide.
  • Next, pull down on the cover until it begins to slide.

Yorum Ekle

Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).
  • Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).

Yorum Ekle

Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
  • Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.

Yorum Ekle

Detach back part of the case by gently lifting up.
  • Detach back part of the case by gently lifting up.

Yorum Ekle

Remove the circuit board from the front part of the radio case.
  • Remove the circuit board from the front part of the radio case.

  • Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.

Yorum Ekle

Scrape off the glue on the outer lining of the speaker using the metal spudger.
  • Scrape off the glue on the outer lining of the speaker using the metal spudger.

Yorum Ekle

Pry the speaker from the case using the metal spudger.
  • Pry the speaker from the case using the metal spudger.

  • This should not take excessive force, so make sure all remaining glue is scraped off from the edges if it will not easily come out.

Yorum Ekle

The speaker is now disassembled!
  • The speaker is now disassembled!

Yorum Ekle

Solder the new wires to the circuit board in the spots denoted by the two red circles.
  • Solder the new wires to the circuit board in the spots denoted by the two red circles.

Yorum Ekle

Place the speaker back inside the shell casing in the same way that it was originally placed.
  • Place the speaker back inside the shell casing in the same way that it was originally placed.

  • Accurately use a polyurethane glue around the rim of the speaker to mount it firmly back inside the plastic casing.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

James Tucker Dunn

Üyelik tarihi: 18-01-2013

371 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 19-43, Regan Winter 2013 Cal Poly, Team 19-43, Regan Winter 2013 üyesi

CPSU-REGAN-W13S19G43

3 Üyeler

9 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 1

Her zaman: 570