Eşyalarını Tamir Et Topluluk Mağaza

Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement

Giriş

This guide will demonstrate how to replace the Trigger Assembly on the Milwaukee Hex Impact Driver 2656-20. The First Two steps will cover disassembly of the drill. The only tool required for this repair is a T-10 Torx Screwdriver. The repair is considered Difficult in difficulty and will take approximately 20 minuets.

Neye ihtiyacın var

  1. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Battery: adım 1, 2 resimden 1. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Battery: adım 1, 2 resimden 2.

    • Squeeze the red buttons on the battery.

    • While squeezing the red buttons, slide the battery forward and out to remove it from the device.

    Düzenle

  2. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Milwaukee Hex Impact Driver 2656-20 Case Disassembly: adım 2, 2 resimden 1. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Milwaukee Hex Impact Driver 2656-20 Case Disassembly: adım 2, 2 resimden 2.

    • Lay the impact driver on its side.

    • Remove eight 16 mm and a single 19 mm screws using the T10 Torx Screwdriver.

    • Separate the two halves by pulling up on the top half.

    • Make sure that the half with the screw heads Is facing up during this process. This will ensure that the components do not fall out.

    • Lay the top half to the side.

    Düzenle

  4. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Trigger Assembly: adım 3, 2 resimden 1. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement, Trigger Assembly: adım 3, 2 resimden 2.

    • Remove the two 6 mm screws on the back of the brush card assembly using the T10 Torx screwdriver.

    • Move the two wires out of the way.

    Düzenle

  5. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement: adım 4, 2 resimden 1. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement: adım 4, 2 resimden 2.

    • Gently pull up on the trigger assembly to remove it from the case.

    Düzenle

  6. Milwaukee Hex Impact Driver 2656-20 Trigger Assembly Replacement: adım 5, 1 resimden 1.

    • Remove the trigger assembly from the device.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 2

Son 30 gün: 18

Her zaman: 1,111