Milwaukee Rotary Hammer 260520 D14A 2016 Gear Housing Cover Replacement

Giriş

For any damage to the Milwaukee Rotary Hammer 260520 D14A 2016 crankcase, which is the grey rear cover for the drill, refer to this guide to replace it.

The purpose of the gear housing cover is to connect the gear case assembly to the rest of the drill casing.

Neye ihtiyacın var

Adım 1 Side Handle Case

Milwaukee Rotary Hammer 260520 D14A 2016 Gear Housing Cover Replacement, Side Handle Case: adım 1, 1 resimden 1.

Remove the battery by sliding it from the base.

Düzenle

Adım 2

Remove two 20.3 mm screws at the right side of the drill base using a Torx T3 screwdriver.

Düzenle

Adım 3

Milwaukee Rotary Hammer 260520 D14A 2016 Gear Housing Cover Replacement: adım 3, 3 resimden 3.

Remove five 20.3 mm screws on the right side of the handle using a Torx T3 screwdriver.

Düzenle

Adım 4

Remove four matte 24 mm screws on the crankcase at the rear cover of the drill (connecting the chuck to the handle) using a Torx T3 screwdriver.

Düzenle

Adım 5

Remove two 24 mm screws on the housing cover beneath the ventilation slots. These screws point into the drill.

Düzenle

Adım 6

Using a Torx T5 screwdriver bit, remove two 26.8 mm screws on each side of the drill housing cover, located beneath the ventilation slots. These screws point upwards.

Düzenle