Ana içeriğe geç

Giriş

Before you start the replacement process, make sure that you have the proper repair tools, a Philips PH0 head and tweezers. You should be careful not to exert too much pressure/force on the components.

This guide will be able to walk you through the steps to replace your Mio ALPHA 2's motherboard.

  1. Remove the four 6.7mm JIS #00 screws from the back cover. Remove the four 6.7mm JIS #00 screws from the back cover.
    • Remove the four 6.7mm JIS #00 screws from the back cover.

  2. Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  3. Pull off the back cover of the watch Use a pair of tweezers to flip up the retaining flap on the  ribbon cable ZIF socket. Remove the ribbon cable from its socket.
    • Pull off the back cover of the watch

    • Use a pair of tweezers to flip up the retaining flap on the ribbon cable ZIF socket.

    • Remove the ribbon cable from its socket.

  4. Remove the four 3.8mm JIS #00 screws from the motherboard. Remove the motherboard with tweezers Remove the motherboard with tweezers
    • Remove the four 3.8mm JIS #00 screws from the motherboard.

    • Remove the motherboard with tweezers

Sonuç

To reassemble your device, follow these instructions in reverse order.

Wong Jun Hua

Üyelik tarihi: 21-05-2018

169 İtibar

2 adet Kılavuz yazıldı

Takım

IUPUI, Team S1-G3, Harley Spring 2018 IUPUI, Team S1-G3, Harley Spring 2018 üyesi

IUPUI-HARLEY-S18S1G3

6 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 106