Giriş

This quick guide will help you disassemble a Mitsubishi T200 phone, install a new screen, and reassemble your device.

Begin disassembling the phone by removing the phone back cover and battery. Begin disassembling the phone by removing the phone back cover and battery.
  • Begin disassembling the phone by removing the phone back cover and battery.

Yorum Ekle

To remove the back plate, loosen and remove the four screws by using a #00 Philips head screwdriver.
  • To remove the back plate, loosen and remove the four screws by using a #00 Philips head screwdriver.

Yorum Ekle

Separate the front plastic component from the motherboard component.
  • Separate the front plastic component from the motherboard component.

Yorum Ekle

Take the circuit board off the motherboard.
  • Take the circuit board off the motherboard.

Yorum Ekle

Unclip the four clips to remove the screen (connected to the clear plastic) from the circuit board. Unclip the four clips to remove the screen (connected to the clear plastic) from the circuit board.
  • Unclip the four clips to remove the screen (connected to the clear plastic) from the circuit board.

Yorum Ekle

Remove the attached ribbon from the circuit board by prying open the gray plastic clip at the top right of the circuit board. Remove the attached ribbon from the circuit board by prying open the gray plastic clip at the top right of the circuit board.
  • Remove the attached ribbon from the circuit board by prying open the gray plastic clip at the top right of the circuit board.

Yorum Ekle

We can now insert the new screen and reassemble the device. Place the ribbon of the new screen into the clip on the top right of the circuit board.
  • We can now insert the new screen and reassemble the device.

  • Place the ribbon of the new screen into the clip on the top right of the circuit board.

Yorum Ekle

Clip the new screen onto the circuit board.
  • Clip the new screen onto the circuit board.

Yorum Ekle

Replace circut board back on top of motherboard.
  • Replace circut board back on top of motherboard.

Yorum Ekle

Take the entire internal assembly and join it with the front plastic housing.
  • Take the entire internal assembly and join it with the front plastic housing.

  • Ensure that the tops of both pieces clip into place before joining the bottom ones.

Yorum Ekle

Join the phone's face assembly to the back plastic housing. Make sure you carefully insert the front into the antenna's clip first.
  • Join the phone's face assembly to the back plastic housing. Make sure you carefully insert the front into the antenna's clip first.

  • Snap the whole unit together.

Yorum Ekle

Firmly replace screws into the backing.
  • Firmly replace screws into the backing.

Yorum Ekle

Bitiş Çizgisi

2 başka kişi bu kılavuzu tamamladı.

Taylor Lewis

Üyelik tarihi: 13-02-2014

14 İtibar

2 adet Kılavuz yazıldı

Takım

Ohio State, Team 1-5, Meza Spring 2014 Ohio State, Team 1-5, Meza Spring 2014 üyesi

OSU-MEZA-S14S1G5

4 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 4

Her zaman: 553