Giriş

Installing a new back panel in this television is straightforward and requires minimal disassembly.

  1. Before disassembling your television, be sure it is powered off and unplugged.
    • Before disassembling your television, be sure it is powered off and unplugged.

    • Remove the single 18 mm Phillips #1 screw on the lamp access panel.

    Yorum Ekle

  2. Pull the lamp access panel off of the back panel of the television by pulling straight back on the left side of the panel near the screw then pulling to the left.
    • Pull the lamp access panel off of the back panel of the television by pulling straight back on the left side of the panel near the screw then pulling to the left.

    Yorum Ekle

    • Loosen the two Phillips #2 screws securing the lamp housing to the television until the screws will swivel vertically.

      • These two screws are permanently attached to the lamp housing and cannot be removed completely.

    Yorum Ekle

    • Using the handle, pull the lamp housing straight back out of the television.

      • Do not touch the glass of the lamp with your bare hands. The oil from your fingers can distort the TV image and lead to other issues.

    Yorum Ekle

    • Remove the following 8 Phillips #1 screws:

      • One 22 mm Phillips #1 in the bottom right corner of the back panel.

      • One 18 mm Phillips #1 in the top middle of the back panel.

      • Six 18 mm Phillips #1 in the rest of the back panel.

    Yorum Ekle

    • Pull the back panel off of the television by gripping the sides and rotating it down.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Herman Chai

Üyelik tarihi: 02-10-2012

172 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 18-39, Regan Fall 2012 Cal Poly, Team 18-39, Regan Fall 2012 üyesi

CPSU-REGAN-F12S18G39

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 9

Her zaman: 744