Ana içeriğe geç

Giriş

How to remove the cutting head's blade cover for replacement or further device service for the Mk Diamond Wet Saw MK660 2010.

Aletler

Hiçbir alet belirtilmedi.

  1. Before you begin, make sure to power off and unplug the device from the outlet. If the clear water pump hose is connected, remove it now. Loosen the plastic knob holding the saw's cutting head in place.
    • Before you begin, make sure to power off and unplug the device from the outlet.

    • If the clear water pump hose is connected, remove it now.

    • Loosen the plastic knob holding the saw's cutting head in place.

    • Lower the cutting head while keeping it steady.

  2. Unscrew the knob. Remove it from the cutting head.
    • Unscrew the knob.

    • Remove it from the cutting head.

  3. Loosen the plastic knob holding the blade cover in place. Loosen the plastic knob holding the blade cover in place.
    • Loosen the plastic knob holding the blade cover in place.

  4. Loosen the wing nut on the blade cover pivot shaft. Remove the wing nut and accompanying washer. Remove the wing nut and accompanying washer.
    • Loosen the wing nut on the blade cover pivot shaft.

    • Remove the wing nut and accompanying washer.

  5. Pivot the blade cover up and pull it off the shaft. Pivot the blade cover up and pull it off the shaft.
    • Pivot the blade cover up and pull it off the shaft.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Carsten Frauenheim

Üyelik tarihi: 10-03-2020

55.444 İtibar

293 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

140 Üyeler

17.046 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 4

Her zaman: 27