Motorola Droid Pro SD Card/SIM Card PCB Board Replacement

Onarım Topluluğuna Katılın - Hesap Oluşturun

Giriş

Before continuing through the replacement process make sure you power down your devices and work in a clean area free of dirt. Also use a static band so you don't damage your device.

Neye ihtiyacın var

1. Adım 1 SD Card/SIM Card PCB Board
  Remove the back cover and battery by using the thumb tabs.
  Düzenle
  
  FixBot'a Sor
  
  Yorum Ekle
  
  1024
2. Adım 2
  Unscrew the 8 back panel screws using the T4 Torx screwdriver.
  Düzenle
  
  FixBot'a Sor
  
  Yorum Ekle
  
  1024
4. Adım 3
  Use a spudger to open the phone along the sides between the back panel and the chrome trim.
  
  It is held together by small clips that lock in. You may have to use a little force to unlock them.
  
  Go around on all sides then pull the back panel off.
  Düzenle
  
  FixBot'a Sor
  
  Yorum Ekle
  
  1024
5. Adım 4
  Gently lift the SD & SIM card board (PCB) as shown in the following pictures.
  
  This will expose the ribbon cable attached to the board and another ribbon cable for the mother board. Remove them both using the spudger.
  
  Once the small one is removed the small board can be pulled off.
  Düzenle
  
  FixBot'a Sor
  
  Yorum Ekle
  
  1024