Ana içeriğe geç
Onarım Topluluğuna Katılın - Hesap Oluşturun

Motorola Droid RAZR Back Cover Replacement

Görüntüleme: 15 B

İstatistikleri görüntüle:

Son 24 Saat:
4
Son 7 Gün:
23
Son 30 Gün:
105
Her zaman:
14.912
Yorumlar: 0

Hiç kimse bu kılavuza yorum bırakmadı. Birinci olacak mısın?

Go to guide comments
Tamamlandı: 7

7 kişi bu kılavuzu "tamamlandı" olarak işaretledi. Sıradaki sen olacak mısın?

Sık Kullanılanlar: 2

2 kişi bu kılavuzu favorilerine ekledi (ve abone oldu). Sıradaki sen olacak mısın?

Gerekli Süre: Tahmin yok
Zorluk: Orta
Motorola Droid RAZR Back Cover Replacement

Replace your nifty Kevlar-clad back cover that you recently discovered isn't actually bulletproof.

Neye ihtiyacın var

Aletler

    1. Motorola Droid RAZR Back Cover Replacement, Back Cover: adım 1, 2 resimden 1. Motorola Droid RAZR Back Cover Replacement, Back Cover: adım 1, 2 resimden 2.
      • Insert a plastic opening tool between the back cover and rear case at the lower left edge of the back cover.

      • Pry the back cover up with the plastic opening tool to free the plastic clips.

      • Continue prying along the left edge of the back cover towards the top of the phone.

      FixBot'a Sor

      Yorum Ekle

    2. Motorola Droid RAZR Back Cover Replacement: adım 2, 3 resimden 1. Motorola Droid RAZR Back Cover Replacement: adım 2, 3 resimden 2. Motorola Droid RAZR Back Cover Replacement: adım 2, 3 resimden 3.
      • Work the plastic opening tool across the top of the back case to free the plastic clips.

      • The top edge of the back case is very thin. Pry carefully to avoid cracking or snapping it.

      • Continue prying down the right side of the back cover to free the remaining clips.

      FixBot'a Sor

      Yorum Ekle

    3. Motorola Droid RAZR Back Cover Replacement: adım 3, 3 resimden 1. Motorola Droid RAZR Back Cover Replacement: adım 3, 3 resimden 2. Motorola Droid RAZR Back Cover Replacement: adım 3, 3 resimden 3.
      • Pull the back cover away from the phone to remove it.

      • The back cover is attached to the battery with a generous amount of adhesive, so you may have to use quite a bit of force to separate the two pieces.

      • The battery must remain in the phone and not come off with the back cover or you will break the power lead.

      • Since the back cover is made of Kevlar, it can handle a fair amount of twisting and tugging without breaking.

      FixBot'a Sor

      Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

İptal et: Bu kılavuzu tamamlamadım.

7 farklı kişi bu kılavuzu tamamladı.

David Hodson

Üyelik tarihi: 04/13/10

157.078 İtibar

127 adet Kılavuz yazıldı

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 gün: 23

Son 30 gün: 105

Her zaman: 14,912