Eşyalarını Tamir Et Topluluk Mağaza

Motorola MBP667CONNECT Camera Stand Replacement

Giriş

If the stand housing is cracked and cannot hold up the camera of the baby monitor, then this guide shows consumers percisely how to remove and replace the stand.

Neye ihtiyacın var

  1. Motorola MBP667CONNECT Camera Stand Replacement, Camera Stand: adım 1, 2 resimden 1. Motorola MBP667CONNECT Camera Stand Replacement, Camera Stand: adım 1, 2 resimden 2.

    • Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.

    Düzenle

  2. Motorola MBP667CONNECT Camera Stand Replacement: adım 2, 1 resimden 1.

    • Use a nylon spudger to remove the casing.

    Düzenle

  4. Motorola MBP667CONNECT Camera Stand Replacement: adım 3, 1 resimden 1.

    • Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.

    Düzenle

  5. Motorola MBP667CONNECT Camera Stand Replacement: adım 4, 2 resimden 1. Motorola MBP667CONNECT Camera Stand Replacement: adım 4, 2 resimden 2.

    • Remove the black circular plastic part.

    Düzenle

  6. Motorola MBP667CONNECT Camera Stand Replacement: adım 5, 1 resimden 1.

    • Remove the white plastic wire housing beneath the black plastic.

    Düzenle

  7. Motorola MBP667CONNECT Camera Stand Replacement: adım 6, 2 resimden 1. Motorola MBP667CONNECT Camera Stand Replacement: adım 6, 2 resimden 2.

    • Now, remove the bottom of the stand by pulling it from the camera.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 3

Son 30 gün: 6

Her zaman: 557