Ana içeriğe geç

Giriş

Use this guide to replace the rear camera of your Motorola Moto G4 Play when it brakes or it doesn't take clear photos.

  1. Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails. Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails. Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.
    • Open case with a plastic opening tool that has the same size as the divot located at the bottom left of the phone. If you don’t have an opening tool, use your finger nails.

  2. Lift the case by the nearest corner to the divot and remove it from the phone. Lift the case by the nearest corner to the divot and remove it from the phone. Lift the case by the nearest corner to the divot and remove it from the phone.
    • Lift the case by the nearest corner to the divot and remove it from the phone.

  3. Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails. Remove battery from your phone. Remove battery from your phone.
    • Place the plastic opening tool into the notch located at the bottom of the battery compartment, and lift upwards. If you don’t have an opening tool, use your finger nails.

    • Remove battery from your phone.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Remove any SIM card and/or memory card present using your hand. Remove any SIM card and/or memory card present using your hand. Remove any SIM card and/or memory card present using your hand.
    • Remove any SIM card and/or memory card present using your hand.

  6. Remove the small silicon cover at the bottom right of the camera using tweezers. Remove the small silicon cover at the bottom right of the camera using tweezers.
    • Remove the small silicon cover at the bottom right of the camera using tweezers.

  7. Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.
    • Remove the sixteen (16) 3mm Phillips PH000 screws securing the midframe.

    • Some phones have two shorter screws, one on each side of the battery (double marked with orange circles at left). If your device has these shorter screws, make sure they go back in their original holes.

  8. Remove the back panel assembly with your hands. Remove the back panel assembly with your hands. Remove the back panel assembly with your hands.
    • Remove the back panel assembly with your hands.

  9. Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board. Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board. Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board.
    • Use the flat end of a spudger to disconnect the rear-facing camera connector from its socket on the mother board.

  10. After detaching the connector, carefully remove the camera using tweezers. If you don't have tweezers, use your hands.
    • After detaching the connector, carefully remove the camera using tweezers. If you don't have tweezers, use your hands.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Paola Rossi

Üyelik tarihi: 15-02-2018

403 İtibar

3 adet Kılavuz yazıldı

Takım

USF Tampa, Team S17-G4, Boczar Spring 2018 USF Tampa, Team S17-G4, Boczar Spring 2018 üyesi

USFT-BOCZAR-S18S17G4

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 22

Her zaman: 313