Giriş

Use this repair guide to replace a motherboard in a Motorola RAZR2 v9m.

  1. Push the rear cover toward the hinge of the RAZR2.  The panel will slide about 3 mm.
    • Push the rear cover toward the hinge of the RAZR2. The panel will slide about 3 mm.

    Yorum Ekle

  2. Pinch the top and bottom edges of the panel and pull it away from the RAZR2.
    • Pinch the top and bottom edges of the panel and pull it away from the RAZR2.

    • The rear panel uses four small hooks to hold it in place. If the panel will not easily pull away, slide the panel more toward the hinge.

    Yorum Ekle

    • Gently pull the white plastic tab to lift the battery away from the RAZR2.

    • The white plastic tab is attached to the phone. Only pull it enough to expose the edges of the battery.

    Yorum Ekle

    • To remove the battery, grasp its edges pull away from the phone.

    • When installing a new battery, be sure the metal contacts on the phone line up with the ones on the battery.

    Yorum Ekle

    • Gently press the pointy end of the spudger into the edge of the bumper until it bows and separates from the phone.

      • The bumper is held in place with adhesive. If you plan on reusing the bumper, then use clean tools to keep the surface sticky.

    • Grab the bowed portion of bumper. Gently lift and peel the bumper away from the phone.

      • Remember that the bumper will be sticky. Place it somewhere clean if you will be reusing it.

    Yorum Ekle

    • Remove the two 4-mm T5 Torx screws, previously hidden beneath the flip stop bumper pad.

    Yorum Ekle

    • Close the phone and flip it onto its back.

    • Remove the two 4-mm T5 Torx screws.

    Yorum Ekle

    • Wedge the spudger about 4 mm into the gap between the phone casing and the rear housing.

    • Pry the rear housing away from the phone until enough is exposed to grasp with your fingers.

    Yorum Ekle

    • Tilt the loosened half of the rear housing away from the phone. The housing should easily separate after tilting it about 45 degrees away from the phone.

    • A small rubber cap (marked in red on the third image) loosely sits on the motherboard. It can easily fall off when removing the rear housing. Take care not to lose it.

    Yorum Ekle

    • Use a pair of tweezers or your fingers to remove the small rubber cap from the motherboard.

    Yorum Ekle

    • Use a plastic opening tool to gently pry the main motherboard cable connector away from the RAZR2.

    Yorum Ekle

    • Use your finger to bend the connector away from the RAZR2.

    Yorum Ekle

    • Use a spudger to flip open the white clamp holding the keypad ribbon in place.

    Yorum Ekle

    • Slide the tip of a pair of tweezers between the motherboard and the keyboard cable.

    • Slide the keyboard cable towards the top of the phone, away from the motherboard.

    Yorum Ekle

    • While holding the main motherboard cable connector away from the RAZR2, gently lift the motherboard away from the phone.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 6

Her zaman: 1,299