Giriş

This guide is for removing the phone's earpiece speaker.

Using a spudger, remove the four rubber covers from over the screws. Using a spudger, remove the four rubber covers from over the screws. Using a spudger, remove the four rubber covers from over the screws.
  • Using a spudger, remove the four rubber covers from over the screws.

Yorum Ekle

Unscrew the cover screws using the T6 bit
  • Unscrew the cover screws using the T6 bit

Yorum Ekle

Loosen and remove the cover with a plastic opening tool. Loosen and remove the cover with a plastic opening tool.
  • Loosen and remove the cover with a plastic opening tool.

Yorum Ekle

Gently loosen the protective cover with the plastic opening tool. Gently loosen the protective cover with the plastic opening tool.
  • Gently loosen the protective cover with the plastic opening tool.

Do not pry from the top or bottom of the metal cover. There are a pair of 1/4" long openings on either side of the metal cover at the midpoint of the case. The plastic teeth which lock into the openings must be withdrawn. I used the point of cuticle sissors to get behind the metal strip under each tooth and pull outwards a small distance to release each tooth. The sides of the cover will spring up.

Fonce - Yanıt

Carefully remove the protective cover from the circuitry Slowly peel the black rubber gasket up off the circuit board. Carefully move the camera out of the way using your hand.
  • Carefully remove the protective cover from the circuitry

  • Slowly peel the black rubber gasket up off the circuit board.

  • Carefully move the camera out of the way using your hand.

  • Use a flat tool to separate the connection between the upper and lower circuit boards.

Yorum Ekle

Gently slip the copper strip out from under the circutry by hand. Gently slip the copper strip out from under the circutry by hand. Gently slip the copper strip out from under the circutry by hand.
  • Gently slip the copper strip out from under the circutry by hand.

Yorum Ekle

Pry out the speaker using your fingers. Pry out the speaker using your fingers. Pry out the speaker using your fingers.
  • Pry out the speaker using your fingers.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

gregatron

Üyelik tarihi: 29-10-2009

72 İtibar

12 adet Kılavuz yazıldı

Takım

Cal Poly, Team 6-6, Maness Fall 2009 Cal Poly, Team 6-6, Maness Fall 2009 üyesi

CPSU-MANESS-F09S6G6

4 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 2,578