Giriş

This guide describes how to replace the button key board, or the processor that interprets key pad information.

  1. Remove battery cover by pushing down release lever at top of phone while prying off cover.
    • Remove battery cover by pushing down release lever at top of phone while prying off cover.

    • Set cover aside.

    Yorum Ekle

  2. Remove battery by grabbing it near the bottom and lifting out.
    • Remove battery by grabbing it near the bottom and lifting out.

    Yorum Ekle

    • Unscrew four corner screws with T6 screwdriver.

      • Note: The two top screws are short and silver. The two bottom screws are black and long.

    Yorum Ekle

    • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

    Yorum Ekle

    • Starting from left side of phone, remove side buttons and place aside.

      • Note: There should be three buttons. One on each side, and the top.

    • Return phone to starting orientation when done.

    Yorum Ekle

    • Gently remove orange ribbon cable by prying up with spudger.

    Yorum Ekle

    • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

      • Note: Orange ribbon cable is fragile and can be broken.

    Yorum Ekle

    • Insert spudger under button board and gently lift, set aside.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

Üyelik tarihi: 26-01-2010

1 İtibar

7 adet Kılavuz yazıldı

Takım

Cal Poly, Team 8-48, Regan Winter 2010 Cal Poly, Team 8-48, Regan Winter 2010 üyesi

CPSU-REGAN-W10S8G48

4 Üyeler

13 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,278