Ana içeriğe geç

Giriş

This guide outlines how to replace an LCD screen on the Moultrie I45 GameSpy camera

Parçalar

Hiçbir parça belirtilmedi.

  1. Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.
    • Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.

    make sure to add commas.

    Step 1- remove the 8, 6mm...

    Step 2- Using a philips head screwdriver, remove the 6, 4mm screws...

    Same thing with step 6. Good page!

    Jesica Bartell - Yanıt

  2. Remove the butterfly nut from the lid arm.
    • Remove the butterfly nut from the lid arm.

  3. Remove the lid-covering.
    • Remove the lid-covering.

  4. Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.
    • Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.

  5. Gently separate the two halves of the case.
    • Gently separate the two halves of the case.

    • The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.

  6. Using a Philips head screwdriver, remove the 12, 3mm screws from the board.
    • Using a Philips head screwdriver, remove the 12, 3mm screws from the board.

  7. Gently remove the circuit board from the face of the camera
    • Gently remove the circuit board from the face of the camera

    Mention the two pieces (black piece) of the LCD screen that you need to remove

    Jesica Bartell - Yanıt

  8. Remove the LCD screen.
    • Remove the LCD screen.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Sean Hill

Üyelik tarihi: 29-01-2015

434 İtibar

4 adet Kılavuz yazıldı

Takım

UW Tacoma, Team 3-7, Rose Winter 2015 UW Tacoma, Team 3-7, Rose Winter 2015 üyesi

UWT-ROSE-W15S3G7

3 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 2

Son 30 gün: 7

Her zaman: 658