N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide

Giriş

If the laser is not turning on, or flickering on your N-Strike Nite Finder EX-3, the problem may be caused by a faulty leaf spring. In order to replace this part, follow the steps in this guide.

Neye ihtiyacın var

Adım 1 Leaf Spring Switch

N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide, Leaf Spring Switch: adım 1, 1 resimden 1.

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
Remove the battery door and take the batteries out.

Düzenle

Adım 2

N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide: adım 2, 3 resimden 3.

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
Lift the side of the blaster off exposing its internal parts.

Düzenle

Adım 3

Work the trigger to ensure the problem is the switch not making a proper connection.
Remove the retaining phillips head 10.2 mm screw below the switch.

Düzenle