Giriş

If pulling the trigger of your Nerf Nite Finder doesn't cause it to fire, the trigger might need to be replaced. This guide shows how to do so.

==CAUTION==

Be aware of springs under compression. Take care so these small parts do not fly off the blaster and get lost.

Parçalar

Hiçbir parçaya gerek yok.

  1. Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
    • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

    • Remove the battery door and take the batteries out.

    Yorum Ekle

  2. Set the blaster on its side with the screws facing up (the blaster will be placed on its left side).  Remove all 14 phillips head, 8.2 mm screws and set them aside.
    • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

    • Lift the side of the blaster off exposing its internal parts.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the phillips head, 10.2 mm screw holding the trigger in place.

    Yorum Ekle

    • Remove the trigger by pulling the piece straight up.

    • Caution: Do not let the spring fly off the spring

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Kyle Schober

Üyelik tarihi: 24-02-2014

622 İtibar

5 adet Kılavuz yazıldı

Takım

Michigan Tech, Team 5-8, Lauer Spring 2014 Michigan Tech, Team 5-8, Lauer Spring 2014 üyesi

MTU-LAUER-S14S5G8

3 Üyeler

9 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 10

Her zaman: 1,029