Giriş

installing the front speaker

Using two fingers, push up on the rear cover.
  • Using two fingers, push up on the rear cover.

Yorum Ekle

The rear cover slides up and off.
  • The rear cover slides up and off.

Yorum Ekle

  • Using the plastic opening tools, pry the left bottom corner of the battery up.

Yorum Ekle

  • Pull the battery up and out.

Yorum Ekle

  • Remove the two Torx T5 screws.

  • Remove the one Philips #00 screw.

#0 Phillis screw

skuhry - Yanıt

  • Using the plastic opening tool, pry up the battery housing upwards.

  • Push pry tool down, undoing the plastic tab.

Yorum Ekle

  • Pry the upper left tab open on the battery housing.

Yorum Ekle

  • Pry the top tab of the battery housing.

Yorum Ekle

  • Pry the right side tab of the battery housing.

Yorum Ekle

  • Pull up on the battery housing.

  • Slide the battery housing out to remove it.

Yorum Ekle

  • Insert the spudger under the connector.

  • Push the spudger up and twist to release the connector.

  • Repeat for the next connector.

Yorum Ekle

  • Push on the USB port to expose the black connector.

  • Use the spudger to pry the connector upwards.

The philips screw holding down the logic board (at the lower right corner in the picture) has to be removed before the board can be pushed back.

Mark - Yanıt

  • Place the spugder under the antenna connector.

  • Pry connector up vertically.

Yorum Ekle

  • Insert the spudger into tab above the camera.

  • Slide upwards until the board detaches from the case.

A philips screw holding down the upper logic board (in the lower left corner of the picture) must be remobed before the board can be detached.

Mark - Yanıt

  • Press the pointed tip of the spudger into the space below the button assembly.

  • Wiggle the spudger tip towards the outside of the button.

  • The button assembly is under some tension and may fly off.

Yorum Ekle

  • Push the pointed tip of the spudger into the base of the side button board.

  • Lift up, the board will disconnect from the case.

Yorum Ekle

  • Push on the lower motherboard until it slides under the case support.

  • The motherboard assembly comes out as a single piece.

  • Save the small black rubber rectangular sound guide under the motherboard, to replace over the microphone.

Be carefull not to tear the home button cable that is in the top right corner!!

zack - Yanıt

  • Using the spudger, pop up the end of the speaker.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Niklas Johnson

Üyelik tarihi: 31-01-2012

1.063 İtibar

18 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 2,199