Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Giriş

Replace your worn out inner dome daughterboard: which contains Atmel ATMEGA328P, NXP Semiconductors 44501 Near-Field Communications Controller, TXC 8.00 MHz Crystal Quartz Oscillator, YF04E, and the status LED.

  1. Squeeze and pull to pop the cap off of the Nexus Q.
    • Squeeze and pull to pop the cap off of the Nexus Q.

  2. Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger. Once the antenna is disconnected, simply pull it off the outside of the inner dome.
    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

  3. LCD iPhone Ekran Tamir Kit'leri

    Ömür Boyu Garantimiz kapsamındaki bütçe seçeneği.

    Shop Kits

    LCD iPhone Ekran Tamir Kit'leri

    Onarım maliyetlerini düşürün, kaliteyi değil.

    Shop Kits
  4. Undo the ZIF connector by prying with a spudger.
    • Undo the ZIF connector by prying with a spudger.

  5. Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.
    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

  6. Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.
    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

  7. Use a spudger to disconnect the daughterboard from the ZIF connector.
    • Use a spudger to disconnect the daughterboard from the ZIF connector.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Alex Thomas

Üyelik tarihi: 31-01-2013

27 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 7-10, Maness Winter 2013 Cal Poly, Team 7-10, Maness Winter 2013 üyesi

CPSU-MANESS-W13S7G10

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 830