This guide is to be used to install the back cover in the event that it becomes damaged. A Phillips screwdriver will be needed to complete this installation.


Hiçbir parçaya gerek yok.

  1. Remove wrist strap by unknotting the strap.
    • Remove wrist strap by unknotting the strap.

    Yorum Ekle

  2. Open SD/Battery cover.
    • Open SD/Battery cover.

    Yorum Ekle

    • Remove the four screws on the bottom of the camera using the Phillips-Head screwdriver.

    Yorum Ekle

    • Pull the silver side panels on each side.

    Yorum Ekle

    • On the right side of the camera (that contains the wrist strap loop), use the screwdriver to remove the two screws holding the backplate in place.

      • Repeat this step for the left side.

    Yorum Ekle

    • Pull the back silver faceplate to separate it from the rest of the camera.

    Yorum Ekle


To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Patty Richeson

Üyelik tarihi: 11-03-2013

75 İtibar

4 adet Kılavuz yazıldı


Clemson, Team 12-5, Benson Spring 2013 Clemson, Team 12-5, Benson Spring 2013 üyesi


4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 383