Ana içeriğe geç

Giriş

This guide will show how to access the motherboard which will give you the ability to remove the lens and flash.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the two 2.8 mm screws on the left side of the camera.
    • Remove the two 2.8 mm screws on the left side of the camera.

  2. Remove the four 2.8 mm screws on the right side of the camera.
    • Remove the four 2.8 mm screws on the right side of the camera.

  3. Remove the three 4.1 mm screws on the bottom of the camera.
    • Remove the three 4.1 mm screws on the bottom of the camera.

  4. Gently lift the rear cover from the camera.
    • Gently lift the rear cover from the camera.

  5. Dizüstü Bilgisayar Bataryaları

    An easy fix for a big power boost.

    Hemen Alışveriş Yapın

    Dizüstü Bilgisayar Bataryaları

    An easy fix for a big power boost.

    Hemen Alışveriş Yapın
  6. Gently lift the screen out of its place.
    • Gently lift the screen out of its place.

    • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

  7. Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.
    • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

  8. Slowly pull the screen from the camera.
    • Slowly pull the screen from the camera.

  9. Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.
    • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

  10. Lift up silver LCD base plate
    • Lift up silver LCD base plate

  11. Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable. Slide the button panel ribbon cable out of its socket on the motherboard.
    • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

    • Slide the button panel ribbon cable out of its socket on the motherboard.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Shauna

Üyelik tarihi: 05-04-2011

750 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 12-32, Maness Spring 2011 Cal Poly, Team 12-32, Maness Spring 2011 üyesi

CPSU-MANESS-S11S12G32

4 Üyeler

5 adet Kılavuz yazıldı

Bir Yorum

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 5,314