Giriş

Before replacing your battery cover door for your Nikon Coolpix S630 you would need to read how to remove back panel and front panel. Removing both back and front panels are necessary to starting this guide.

Parçalar

Hiçbir parçaya gerek yok.

  1. The battery compartment is located on the bottom of the camera.
    • The battery compartment is located on the bottom of the camera.

    • Place your thumb on the battery door.

    • Slide the door away from the camera in the direction the arrow points to.

    Yorum Ekle

  2. Slide the yellow tab towards the back of the camera.
    • Slide the yellow tab towards the back of the camera.

    • The battery should pop out.

    • Remove the battery.

    Yorum Ekle

    • Press the memory card down into the camera.

    • The memory card should pop out.

    • Remove the memory card.

    Yorum Ekle

    • Unscrew the two 3.5mm Phillips screws from the side with the AV outlet.

    • Unscrew the 3.5mm Phillips screw from the opposite side of the camera.

    • Unscrew the six 3.5mm Phillips screws from the bottom of the camera.

    Yorum Ekle

    • Carefully remove the back casing from the camera.

    • Be mindful when removing the back casing as there is a ribbon that still connects the back casing to the motherboard.

    Yorum Ekle

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Place the plastic opening tool underneath the ribbon tab as shown. Gently lift the tab up.

    • Gently pull the ribbon from the logic board with tweezers.

    • With the ribbon disconnected, the back casing should now be detached from the rest of the camera.

    Yorum Ekle

    • Locate a small, rectangular flap above the battery cover door.

    • Push the small, rectangular flap back through the hole.

    Yorum Ekle

    • Using the plastic opening tool, gently pry open the front cover. Gently remove the front cover.

    • Make sure to hold the camera down when removing the front cover.

    Yorum Ekle

    • Locate the battery cover door.

    Yorum Ekle

    • Press and slide the cover door open.

    Yorum Ekle

    • Locate the small rod that is securing the door in place

    • Using a tweezers, grab the rod and slowly pull the rod out

    • Note: Be careful as you try to pull the rod out because the spring may pop out

    Yorum Ekle

    • Replace battery cover door.

    • Note: To reinstall a new battery cover door, make sure you have these parts: spring, rod, and the battery cover door.

    Yorum Ekle

    • Place battery cover door back into place with spring between the insertion holes.

    • Using a tweezers, gently slide the rod through the insertion holes and through the spring.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Aulivia Bounchaleun

Üyelik tarihi: 19-04-2013

10 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 8-56, Johann Spring 2013 Cal Poly, Team 8-56, Johann Spring 2013 üyesi

CPSU-JOHANN-S13S8G56

4 Üyeler

9 adet Kılavuz yazıldı

Bir Yorum

I am stuck on step 8. How am I supposed to hold it down and pull the front cover off. I can only get the corner up where the battery goes.

toolshell - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 953