Eşyalarını Tamir Et Topluluk Mağaza

Nikon D5200 Screen Replacement

Giriş

Make sure to have your soldering iron ready prior to replacing the screen. This will make the process go faster as the time it takes to heat the soldering iron varies.

Neye ihtiyacın var

  1. Nikon D5200 Screen Replacement, Screen: adım 1, 3 resimden 1. Nikon D5200 Screen Replacement, Screen: adım 1, 3 resimden 2. Nikon D5200 Screen Replacement, Screen: adım 1, 3 resimden 3.

    • Fully open the LCD panel so that its screws are easily accessible.

    • Remove the two 2.5 mm screws from the outside edge of the screen casing, and the two 3.5 mm screws from the inside edge.

    Düzenle

  2. Nikon D5200 Screen Replacement: adım 2, 3 resimden 1. Nikon D5200 Screen Replacement: adım 2, 3 resimden 2. Nikon D5200 Screen Replacement: adım 2, 3 resimden 3.

    • Pry open the plastic casing using the opening tool or by hand.

    Düzenle

  4. Nikon D5200 Screen Replacement: adım 3, 3 resimden 1. Nikon D5200 Screen Replacement: adım 3, 3 resimden 2. Nikon D5200 Screen Replacement: adım 3, 3 resimden 3.

    • Use the plastic opening tool to pop up the latch holding the ribbon cable on the right side of the circuit board, and remove it.

    • Use the plastic opening tool to pry the ribbon cable on the left side of the circuit board up and off of its socket.

    Düzenle

  5. Nikon D5200 Screen Replacement: adım 4, 2 resimden 1. Nikon D5200 Screen Replacement: adım 4, 2 resimden 2.
    Bu adımda kullanılan alet:
    Tweezers
    $4.99
    Satın Al

    • Using tweezers, unplug the smaller cable.

    Düzenle

  6. Nikon D5200 Screen Replacement: adım 5, 2 resimden 1. Nikon D5200 Screen Replacement: adım 5, 2 resimden 2.

    • Desolder the three small wires on the left side of the circuit board.

    • Soldering irons become very hot when in use. Take all necessary precautions to avoid injury.

    Düzenle

  7. Nikon D5200 Screen Replacement: adım 6, 3 resimden 1. Nikon D5200 Screen Replacement: adım 6, 3 resimden 2. Nikon D5200 Screen Replacement: adım 6, 3 resimden 3.

    • Using a spudger, remove the display from its casing.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

15 farklı kişi bu kılavuzu tamamladı.

Yazar

5 tane daha katılımcı ile

Alexander Corn

Üyelik tarihi: 08/26/15

1.312 İtibar

5 adet Kılavuz yazıldı

Rozetler: 14

+11 tane daha rozet

Ekip

USF Tampa, Team 3-1, Eyestone Fall 2015 USF Tampa, Team 3-1, Eyestone Fall 2015 üyesi

USFT-EYESTONE-F15S3G1

4 Üyeler

5 adet Kılavuz yazıldı

9 Yorum

Do I need to de-solder if I'm just replacing the window glass?

isaac - Yanıt

To isaac: no. The exterior glass is separate from the LCD.

Joseph Morris - Yanıt

Do you recommend the replacent for LCD sold on Ebay?

g_atki - Yanıt

Where did you find the replacement screen? The one I ordered that says it's for the d5200 is not the same as the one in it or in your pictures.

Heather Miller - Yanıt

How do you disconnect the multi-plug that is shown connected in image 4 and disconnected in image five? Does it unclip or slide out?

Amanda Bruyninckx - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 13

Son 30 gün: 45

Her zaman: 12,504