Giriş

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

Yorum Ekle

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

Yorum Ekle

Pull up on the tab to remove the batteries.
  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

Yorum Ekle

Use a 00 Phillips head screwdriver to remove the four screws from inside the case.
  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

Yorum Ekle

Remove the battery compartment from the camera.
  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Zachary Phillips

Üyelik tarihi: 08-04-2011

178 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 25-26, Garner Spring 2011 Cal Poly, Team 25-26, Garner Spring 2011 üyesi

CPSU-GARNER-S11S25G26

3 Üyeler

6 adet Kılavuz yazıldı

Bir Yorum

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 17

Son 30 Gün: 91

Her zaman: 9,044