Eşyalarını Tamir Et Topluluk Mağaza

Ninja NJ600 Fan Replacement

Giriş

This guide will illustrate how to disassemble and replace the fan inside your blender.

Neye ihtiyacın var

  1. Ninja NJ600 Fan Replacement, Blender Base Cover: adım 1, 2 resimden 1. Ninja NJ600 Fan Replacement, Blender Base Cover: adım 1, 2 resimden 2.

    • Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.

    Düzenle

  2. Ninja NJ600 Fan Replacement: adım 2, 2 resimden 1. Ninja NJ600 Fan Replacement: adım 2, 2 resimden 2.

    • Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.

    • The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.

    Düzenle

  4. Ninja NJ600 Fan Replacement: adım 3, 3 resimden 1. Ninja NJ600 Fan Replacement: adım 3, 3 resimden 2. Ninja NJ600 Fan Replacement: adım 3, 3 resimden 3.

    • Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.

    • Be careful not to damage the two wires that are keeping this third layer attached to the base.

    Düzenle

  5. Ninja NJ600 Fan Replacement, Fan: adım 4, 1 resimden 1.

    • Hold the fan steady and use a wrench or pliers to remove the nut in the image.

    • The fan is sharp. Use caution when handling with bare hands.

    • A towel or gloves may be useful when holding the fan for this step.

    Düzenle

  6. Ninja NJ600 Fan Replacement: adım 5, 1 resimden 1.

    • Hold the fan and use the flathead 4.0 screwdriver to loosen the washer.

    • The fan is sharp, use caution when handling with bare hands.

    • You may use a towel or gloves to avoid handling the fan with your bare hands.

    Düzenle

  7. Ninja NJ600 Fan Replacement: adım 6, 2 resimden 1. Ninja NJ600 Fan Replacement: adım 6, 2 resimden 2.

    • Slide the washer and fan off of the screw.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

4 tane daha katılımcı ile

Ryan Heller

Üyelik tarihi: 04/01/15

107 İtibar

1 Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

Ekip

Cal Poly, Team 24-2, Lancaster Spring 2015 Cal Poly, Team 24-2, Lancaster Spring 2015 üyesi

CPSU-LANCASTER-S15S24G2

4 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 2

Son 30 gün: 13

Her zaman: 1,335