Ana içeriğe geç

Ninja Professional BL610 LED Replacement

Neye ihtiyacın var

  1. Ninja Professional BL610 LED Replacement, LED: adım 1, 1 resimden 1.
    • Remove six screws (12mm long, 6mm head diameter) from bottom of the blender using a Phillips #2 screwdriver.

  2. Ninja Professional BL610 LED Replacement: adım 2, 1 resimden 1.
    • Remove six screws (12mm long, 6mm head diameter) from component housing using Phillips #2 screwdriver.

  3. Ninja Professional BL610 LED Replacement: adım 3, 1 resimden 1.
    • Remove five screws from circuit board using Phillips #2 screwdriver.

  4. Ninja Professional BL610 LED Replacement: adım 4, 1 resimden 1.
    • Once the screws are removed, lift the circuit board to access the back.

  5. Ninja Professional BL610 LED Replacement: adım 5, 1 resimden 1.
    • Locate the LED you wish to replace and note its position on the opposite side of the circuit board.

  6. Ninja Professional BL610 LED Replacement: adım 6, 1 resimden 1.
    • Desolder both of the LED leads and remove the LED light. Note the orientation of LED, this is important for replacing the LED. The Replacement LED needs to be soldered in the same orientation.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Rosniel Castro

Üyelik tarihi: 09/27/17

482 İtibar

4 adet Kılavuz yazıldı

Ekip

USF Tampa, Team S14-G3, Boczar Fall 2017 USF Tampa, Team S14-G3, Boczar Fall 2017 üyesi

USFT-BOCZAR-F17S14G3

4 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 132