Giriş

This is how you remove the bottom cover

Remove the expansion pack cover by pushing in the tab and pulling out.
  • Remove the expansion pack cover by pushing in the tab and pulling out.

Yorum Ekle

If your system uses a jumper pack, the same procedure applies to remove it.
  • If your system uses a jumper pack, the same procedure applies to remove it.

  • A small spoon can be used in place of a spudger.

  • Lever the expansion pack out using a metal spudger.

Yorum Ekle

  • Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

Yorum Ekle

  • Remove the two front feet of the N64.

Yorum Ekle

  • Rotate to top side up and lift off top cover.

Yorum Ekle

  • Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

I’m not entirely certain if it's a common difference, but my nintendo 64 doesn’t have fourteen screws, but rather, 8 screws, and instead of 3 heat sinks, it only has the one separate heat sink on the chip close to the memory expansion pack. additionally, aside from the 6 screws closest to the expansion pack, the two other screws are held on by nuts under the metal piece.

Avery Duncan - Yanıt

  • Remove the metal plate indicated in the example by sliding it back and then lifting it up.

Yorum Ekle

  • Remove the two screws indicated in the example using the smaller Phillips screwdriver.

Yorum Ekle

  • Remove the screw to the right of the LED light using the larger Phillips screwdriver.

Yorum Ekle

  • Remove the small metal bracket from the back of the expansion pack slot.

Yorum Ekle

  • Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

Yorum Ekle

  • Remove the small metal bracket behind the expansion slot using the spudger.

Yorum Ekle

  • Remove the seven screws indicated in the example using the larger Phillips screwdriver.

Yorum Ekle

  • Lift off and remove the metal plate as indicated in the example.

Yorum Ekle

  • Remove the four screws indicated using the #1 Phillips screwdriver.

Yorum Ekle

  • Lift up and remove the motherboard.

Yorum Ekle

  • Remove everything from the bottom cover.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

10 başka kişi bu kılavuzu tamamladı.

tonymag28

Üyelik tarihi: 28-10-2009

1.608 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 5-4, Regan Fall 2009 Cal Poly, Team 5-4, Regan Fall 2009 üyesi

CPSU-REGAN-F09S5G4

7 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 6

Son 7 Gün: 61

Son 30 Gün: 374

Her zaman: 15,111