Giriş

If you have to replace the logic board than use this installation instruction for the logic board.

Parçalar

Hiçbir parçaya gerek yok.

Remove the back cover of your cell phone by pushing the small slider with your fingernail towards the top of the phone.
  • Remove the back cover of your cell phone by pushing the small slider with your fingernail towards the top of the phone.

  • Lift off your cell phone's back cover.

Yorum Ekle

Use your index finger to first push down and then lift up the battery as shown.
  • Use your index finger to first push down and then lift up the battery as shown.

  • Remove the battery from your cell phone.

Yorum Ekle

  • Open the front cover of your cell phone with the plastic opening tool or finger nail.

  • Lift the cover upwards, starting from the bottom below the keypad.

Yorum Ekle

  • Lift the keypad off of the keyboard as it is not attached to the phone anymore.

  • If you want to clean your keyboard do not use chemical cleaners or too much water, instead, use a damp cloth.

  • It may be tricky to get the keypad in the right position while closing the front cover for the reassembly. Ensure they are aligned properly before closing the front cover!

Yorum Ekle

  • Remove six Torx 6 screws with the screwdriver.

Yorum Ekle

  • Remove the frame that holds the keyboard and the display.

Yorum Ekle

  • Lift the logic board of out the rear case of the phone.

Yorum Ekle

  • This is the logic board of your cell phone.

  • Make sure that you get the right logic board to replace your old one by comparing the serial numbers on it.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Tim Bergmann

Üyelik tarihi: 18-01-2010

35 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-17, Maness Winter 2010 Cal Poly, Team 3-17, Maness Winter 2010 üyesi

CPSU-MANESS-W10S3G17

4 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 2,038